Skip to main content

How do I record words or sounds onto the FluentPet buttons?

Updated over a week ago

SPEAK UP! BUTTONS

  • Remove the battery tab on the back of the Button

  • To record a word, flip the black switch located on the bottom of the Button to the dot-icon (record).

  • Hold the button down until you hear a beep, keep holding and say your word.

  • When released, the button will beep twice.

  • Flip the switch back to the triangle icon (play)

PLEASE NOTE: Some buttons will play the recording instructions ("To record a word...") in both play and record modes. Please record as usual by holding the button down in record mode.)

CONNECT BUTTONS

  • REQUIRE THE FLUENTPET APP AND THE CONNECT BASE SPEAKER

  • To activate the Button to link for the first time after you have connected your Base, pull out the tab. The Button will begin blinking Cyan.

  • Press the Connect Base Speaker's button. The Base will blink Cyan.

  • When the Button has connected, the Base will chime three times.

  • In the FluentPet App, you will be able to record your word.

  • If you need further assistance, please visit: Onboarding: Setting Up your Connect Buttons

BASIC BUTTONS (Gen 1 - no longer in production)

  • Flip the switch on the side of the Button to the left (record mode)

  • Hold the button down for three seconds, and say your word after you hear the beep.

  • When released the button will beep twice.

  • Slide the switch to the right to change to play mode. In play mode, your learner is prevented from accidentally erasing the recording.

Did this answer your question?